Dynamix DW 2 FXO Manuel d'utilisateur télécharger pdf (Page 62)

3.24 Routing Table

Routing Table is a rule to define the destination of the calls you make. You could

define the rules by the number you dial or by the ports. The Routing Table

button will show you the configuration table. (see figure 3.28)

In fact, there are three directions of the incoming calls (from IP or FXO side).

The explanation of the default routing is as below:

The location with

the incoming calls

The location with

the destination

The explanation

IP (Default) Fxo

The destination will be the FXO port

when the calls from the IP side

without any define rules.

Fxo (Default) IP

The destination will be the IP side

when the calls from the FXO port

without any define rules.

Figure 3.28: Routing Table

 Index – The list number of the Route Table.

 Default – For change the default setting. Users have to pick the direction

for the default setting changed.

 Prefix – The prefix number for the dialed digits. The call will be followed this

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 216 217

Pas de commentaire

Dynamix DW 2 FXO Manuel d'utilisateur Page 62