Dynamix DW 2 FXO Manuel d'utilisateur télécharger pdf (Page 180)

to login prompt.

usr/config$ quit

Disconnecting...

Note: It is recommended that type the “quit” command before you leave the

console. If so, FXO GateWay will ask password again when next user connects

to console port.

4.2.3 [debug]

Open debug message will show up specific information while FXO

GateWay is in operation. After executing the debug command, it should

execute command debug -open as well. One example is demonstrated

below.

usr/config$ debug -add h323 vp

usr/config$ debug -open

Parameters Usage:

-status Display the enabled debug flags.

-add Add debug flag.

-- h323 : h323 related information

-- vp : voice related information

-delete Remove specified debug flag.

-open Start to show debug messages.

-close Stop showing debug messages.

The debug command was designed for the Technical Engineer. Please

contact with your vendor before you are using this command.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 216 217

Pas de commentaire

Dynamix DW 2 FXO Manuel d'utilisateur Page 180