Dynamix UM-S Manuel d'utilisateur télécharger pdf (Page 22)

G.shdsl Router User Manual 152

The difference Protocol need to setup difference WAN parameters. After knowing the Ptorocol

provided by ISP, you have to ask the necessary WAN parameters to setup it.

Bridge EoA

Route EoA

IPoA

PPPoA

PPPoE

Step 5: Install the SHDSL Router

To avoid possible damage to this Router, do not turn on the router before Hardware

Installation.

ü Connect the power adapter to the port labeled DC-IN on the rear panel of the product.

ü Connect the Ethernet cable.

Note: If the 1-port router is directly connected to PC or NB, the Ethernet cable has to be used

cross over one. If the 1-port router is connected to hub or switch, be sure that the hub or

switch supporting auto-sensing. If yes, both cross over and none cross over Ethernet

cable are suitable. If not, only pass through Ethernet cable could be used. The 4-port

router supports auto-MDIX switching hub so both through and cross-over Ethernet cable

can be used.

ü Connect the phone cable to the product and the other side of phone cable to wall jack.

ü Connect the power adapter to power source.

ü Turn on the PC or NB which is used for configuration the Router.

VPI:

VCI:

Encapsulation:

IP Address:

Subnet Mask:

Gateway:

DNS Server:

Host Name:

(if applicable)

VPI:

VCI:

Encapsulation:

Gateway:

Host Name:

(if applicable)

VPI:

VCI:

Encapsulation:

IP Address:

Subnet Mask:

Gateway:

DNS Server:

Host Name:

(if applicable)

VPI:

VCI:

Encapsulation:

User Name:

Password:

DNS Server:

Host Name:

(if applicable)

IP Address:

(if applicable)

VPI:

VCI:

Encapsulation:

User Name:

Password:

DNS Server:

Host Name:

(if applicable)

IP Address:

(if applicable)

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 101 102

Commentaires sur ces manuels

Pas de commentaire

Dynamix UM-S Manuel d'utilisateur Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Dynamix UM-S