Dynamix DW-02 Manuel d'utilisateur télécharger pdf (Page 80)

User Manual

FXS Gateway Overview

Two Sets FXS Gateway

Step 1. The WAN IP Address obtained from ADSL has two kinds of methods. One is

fixed IP Address, while user applies for one or more fixed IP Addresses. Another

is dynamic IP Address while user applies for dial-up connection way.

Another is dynamic IP Address while user applies for dial-up connection way.

Step 2. The LAN IP Address of User’s PC can be set as DHCP client in order to gain

a valid one.

Step 3. Assign an IP address to each set using DHCP or fixed address.

Step 4. Enable the IP Sharing function for each set using following command.

Fixed IP Address

usr/config$ ifaddr –ipsharing 1 210.11.22.33

Step 5. Configure separate SIP port and RTP port for each set to prevent from port

conflict. For example, if set A uses the default settings (SIP port: 5060, RTP port:

16384), you must change set B’s setting to SIP port equal to 5061 and RTP port

equal to 26384 for instance.

Change SIP port – usr/config$sip –port 5061

Change RTP port– usr/config$sip –rtp 26384

Step 6. Use the Port Forwarding or Port Redirection function provided by IP Sharing

device (Router). See following for example.

>Advanced setting > NAT setting > Port Redirection

Active Configuration

Items

Service name Protocol Actual Port Virtual IP Virtual Port Enable

- 70 -

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 122 123

Pas de commentaire

Dynamix DW-02 Manuel d'utilisateur Page 80